A very quick and easy way to add some basic animation (head left/right pan) to a blow mold skeleton using the servos and the EFX-TEK Prop-1 control board.
Our take on a windshield wiper motor powered Monster In A Box with a Prop 1 Controller for the brains.
Decrepid skulls and bones protruding from stone looking walls emitting vague, sinister whispering.
Sitting off in a corner, four rats calmly chew on a half eaten human leg. A relatively simple but effective motorized prop.
A fresh from the grave skeleton sits in his drawing room reading his favorite Poe poems while his pet cat and raven listen with interest. Around him poltergeists play with the books on his bookshelf, make his family portrait bleed and write ominous messages on the wall.
LED Spotlights: Our take on LED spotlights. A step-by-step guide.
Relay Driver: Trigger a 12V relay using logic (low) voltage.
LED Oscillator: Alternate two LEDs on and off.
Relay Timer: A simple timed relay circuit.
12V Unregulated Power Supply: A simple supply with sufficient power to run a windshield wiper motor.
12V 1.5A Regulated Power Supply: A simple supply with enough regulation for most uses.
Quad Relay Board: Four 12V relays that can be triggered using logic (low) voltage.
LED Oscillator: Alternate two LEDs on and off.
Relay Timer: A simple timed relay circuit.
12V Unregulated Power Supply: A simple supply with sufficient power to run a windshield wiper motor.
12V 1.5A Regulated Power Supply: A simple supply with enough regulation for most uses.
Quad Relay Board: Four 12V relays that can be triggered using logic (low) voltage.